Launch X-431 ADAS PRO - 3.5 Laser Module Installation and Battery

LAUNCH X-431 ADAS PRO Calibration Tool User Manual
15
3.5 Laser Module
Fig. 3-5
No.
Description
1
Output of the laser beam
Output for laser beam.
Use the laser beam to read the actual value at the scales of the cross
member and at wheel clamp.
2
Mounting bolt
Use this to secure the laser module on the cross member.
3
Switch
Switch the laser on and off.
4
Battery compartment cover
3 type AA batteries can be inserted into the battery compartment.
Installing/replacing the batteries
Proceed as follows to replace the batteries:
1. Switch off the laser beam (1) with the switch (3).
2. Loosen the screw of the battery compartment cover (4), and then push it along the
indicator to remove it.