Launch X-431 ADAS PRO - Page 16

X-431 ADAS PRO Calibration Tool User Manual
12
are available on it.
2
Handle
For moving and holding the beam lifter easier.
3
Slider
For lifting the cross member up or dropping it along the lifter.
4
Mouting holes
5
Bearing
Never collide it abruptly when installing the beam lifter. Doing so may
cause damage to it.
6
Cross-linking bracket 1
7
Cross-linking bracket 2
8
Cross-linking bracket 3
A red scale indicator is installed on the bracket for indicating the height of
the calibration frame.
9
Feed screw nut
When decending the calibration frame, it falls along the lead screw. If it
touches to the limit switch, it will stop automatically. Under the
circumstances, NEVER force to descend it again to avoid damage to the
limit switch.
10
Tuning knob
Controls the ascending/descending speed of the slider (3).
11
Rocker switch
It has total 3 control levels: Up, Stop and Down.