Leach 2R-III - Page 32

22 Safety
7. Lower the tailgate until both safety props lean against the body base using the TAILGATE lever.
Figure 2-6 Props leaned against body base
Putting the Tailgate Safety Props Back in Place (for units with tailgate clamps)
To put the tailgate safety props back into their stored position:
1. Start the engine.
2. Turn the pump ON.
3. Raise the tailgate by about 3 feet using the TAILGATE lever (see Figure 2-4).
4. Swivel back each safety prop and latch it into place under the tailgate (see Figure 2-7 and Figure
2-8).
Figure 2-7 Putting back props into stored position
Danger!
Stand clear of tailgate path while putting the safety props back into their stored position.