USER’S MANUAL
OBDII Auto Scanner
17
I/M Readiness
Since DTCs Were Cleared
This Drive Cycle
4.2.3 I/M Readiness
I/M refers to Inspection and Maintenance that is legislated by the
Government to meet federal clean-air standards. I/M Readiness
indicates if or not the various emissions-related systems on the vehicle
operating properly and ready for I/M testing.
The purpose of the I/M Readiness Monitor Status is to indicate which of
the vehicle described in Chapter 2.5), and which ones have not yet run
and completed testing and diagnosis of their designated sections of the
vehicle system.
The I/M Readiness Monitor Status function also can be used (after
repair of a fault has been performed) to confirm that the repair has been
performed correctly, and/or to check for Monitor Run Status.
Select [I/M Readiness] and press [ENTER], the screen will display the
interface as shown below:
Notes:
Before performing this function, make sure to retrieve and record the
trouble codes.
After clearing, you should retrieve trouble codes once more or turn
ignition on and retrieve codes again. If there are still some trouble codes in
the system, please troubleshoot the code using a factory diagnosis guide,
then clear the code and recheck.
Erase DTC
Emission-Related Diagnostic
Information has been Cleared!
To Next Page
Loading...