Test the best location for the Baby Unit - LF925HD
| LF925HD-2
If you plan to install your Baby Unit in a designated location, and use your home Wi-Fi
network to connect your video monitor, you need to test which of your selected
monitoring areas within the house have good Wi-Fi signal strength.
After you have powered on your Parent Unit you can check the Parent Unit’s Wi-
Fi signal strength by going to:
, then select Configure Wi-Fi and
choose Connection Status.
Adjust the distance between your Baby Unit and the Wi-Fi router if needed. Once you
have identified the suitable location, you can install your Baby Unit.
Tip:
Depending on surroundings and obstructing factors that affect signal strength, such as distance and internal walls, you
may experience reduced Wi-Fi signal. To improve the Wi-Fi signal strength, adjust the distance or direction of your
Parent Unit. Check with your Parent Unit again.
To Next Page
Loading...
