LEHNER SuperVario - Displaying the Spreader Type; Number of Spreaders; Displaying the Motor; Headland Manager (Optional Accessory)

Operating instructions
Settings and displays
22
4.7 Displaying the spreader type
The controller is intended for various spreaders.
The SuperVario® is programmed at the factory. You can operate several
LEHNER spreaders with this control unit.
Press the toggle switch: the setting
is saved. Press the next menu item
or main switch:
the setting is saved and the machine
isswitchedo󰀨.
Spreader type 0
SuperVario
4.8 Number of spreaders
This option is only activated for the Duo controller (optional accessory).
4.9 Displaying the motor
The SuperVario ®canbeequippedwith2di󰀨erentdrivemotors.
The controller is programmed at the factory and set to the motor installed.
The setting cannot be changed.
4.10 Headland manager (optional accessory)
If the headland manager is connected, an * is
displayed at the end of the second line.
Speed 200*
Slide 29
With the headland manager, the slide is automatically opened when
the hydraulics are lowered and automatically closed when lifting.
The slide can be stopped and closed manually at any time using the control
panel.
When starting work using the headland manager, the slide must initially
be opened manually.
The signal can be detected by means of a 7-pin plug or a sensor signal.