LEHNER SuperVario - Checks; Spreading Width and Turning Procedure

Operating instructions
Settings and displays
24
4.11 Checks
Voltage check
In order to check the operating voltage (in V), the spreader must be on and
thehopperlled.
Press the button for 5 seconds.
The operating voltage is displayed
for 8 seconds.
Factory recommendation
min. 12.6 V.
Voltage 14.0 V
Performance check
The motor is set at the factory. No changes are permitted, otherwise the drive
and control parameters no longer match.
To check the performance data, the spreader must be on.
Keep button pressed.
The following information is displayed:
Line 1: current drive motor,
power consumption in watts,
and exact speed.
Line 2: R value for factory-internal
data, the motor voltage in volts,
the current consumption of the motor
in ampere.
TLB 23.4W 201
91R 3.4V 6.9A
4.12 Spreading width and turning procedure
Reference values for the spreading widths of individual spreading materials
are available in the spreading charts included.
If you turn the spreader, please note that the spreading material continues
torollonrmsurfaces,whileontheelditfallsdirectlyintothesurfacesoil.
Inaddition,theowquantitiesdi󰀨erfromthetestingvaluesduetovarious
vibrationsduringelduse.