Leica ComGate10 - Short Message Service (SMS)

Leica ComGate10, Technical Data
42
5.4 Short Message Service (SMS)
Description Use SMS to control the wireless router of the ComGate10. Send an SMS to the phone
number of the SIM card in the ComGate10.
Valid commands
Example of an SMS
response to a
status request
Command Description
status An SMS with the following information is returned:
• Signal strength
• Connection state (up/down)
• Current IP address of the mobile (ppp) interface
• Status digital I/O
reboot The wireless router is restarted. The initialisation is finished when
the “Status” LED on the front panel of the wireless router has
stopped blinking.
output
{channel}
{action}
Example: output 2 rec
To switch the digital output.
Possible channel numbers:
• {1}
• {2}
Possible actions:
• {on}
To close the circuit breaker of the digital output.
• {off}
To open the circuit breaker of the digital output.
• {rec}
Stands for recycle power.
To open/close the circuit breaker for DO2 and close/open the
circuit breaker for DO1.
This can be used to reboot any sensor which is connected to the
ComGate10.
SMS response Description
System ComGate10 Name of the system
(00112Bxxxxxx) Serial number of ComGate10
Communication
state
WAN1: LAN2 is disabled (0.0.0.0) No connection established by
WAN interface
Communication
state
WAN2: WWAN1 is up Connection to the Internet by the
mobile interface
(123.111.123.111,
Mobile1, HSPA, −91 dBm)
(Assigned IP address, signal
quality, strength)
State digital I/O DIO: IN1=off, IN2=off,
OUT1=off, OUT2=on
State of every available digital I/O