48
Supplementary information
Tube series
2 tube series are available for DM LS micro-
scopes. Note that the field of view number might
be limited → p. 25 – 26:
Tubes from the DML range (Fig. 35).
Tubes for polarized light microscopy are
identified by the extra letter P, e. g. Binocular
tube LBP 25-0/4. The Pol tube is exactly aligned
for polarized light microscopes by an orientation
pin and special Pol eyepieces with ready
aligned cross line (right-hand eyepiece only); it
can also be used without restriction on ordinary
DM L microscopes.
Tubes from the DMR research microscope
range (Fig. 37).
In combination with the tube adapter R/L 25-4/7
(36.2), these can also be used on all micro-
scopes in the DM LS range. Special tubes
enable, for example, graticule or slide overlay,
etc.
Intermediate modules*
Attention:
When using intermediate modules, remember
that the eyepiece field of view number may be
affected → p. 25 – 26.
Ergomodule*
By integrating one or several Ergomodules
L 2/25 (36.3), the viewing port of the microscope
can be raised by 30 mm for each one.
Magnification changer*
For stepwise additional increase of the total
magnification by the factors 1.25x, 1.5x and 2x.
→ p. 25, Fig. 36.1.
Fig. 35 Tube range L
1 Monocular tube LMP* –/–/7, 2 Binocular observation tube
HC LB 0/3/4, 3 Ergonomy tube, binocular, viewing angle 0– 35°
HC LVB 0/4/4, 4 Trinocular tube H L1T 4/5/7, with fixed beam-
splitter (50 % to the vertical exit, 50 % to the binocular port),
5 like 4, but with adjustable viewing angle 0 – 35° (HC L1VT
0/4/4), 6 Trinocular with 3 switching positions HC L3TP 4/5/7,
7 Photo adapter tube for tube (6), 8 Photo adapter tube for
tube (6) with 2 exits (50 %/50 %)
* no longer produced
!
12 3
45 6
7
8
To Next Page
Loading...
