111
UNITY MOTORHOME WATER AND PLUMBING SYSTEM
TRUMA AQUAGO
®
WATER
HEATER
SWITCHING ON THE APPLIANCE
1� Open the access door�
2� To switch on the appliance, switch the POWER
switch to one of the two “ON” positions. Both ON
positions on the POWER switch have the same
function� Choose your preferred position�
• When the green power ON LED (1) is lit, the
appliance is switched on�
• If the red error code LED (2) is lit or ashes,
there is a fault or warning�
AQUAGO
®
COMFORT / AQUAGO
®
COMFORT PLUS
The appliance is now ready for using the control
panel inside your vehicle.
OPERATING MODES
AquaGo
®
comfort / AquaGo
®
comfort plus feature a
control panel to select the operating mode�
3� Turn the propane "shut off" switch
4
to ON�
4
4
4� Press the exterior water heater switch
5
to
either Eco or Comfort ON position (refer to water
heater operating instructions in the Motorhome
Information Kit for detailed instructions).
5� Ensure the water heater valves
6
are in the
position shown for normal operation�
6
Always refer to the owner’s manual for the
water heater (included in your Motorhome
Information Kit).
NOTICE
WINTERIZING
Refer to the water heater operating instructions
located in the Motorhome Information Kit for detailed
winterizing procedures.
To Next Page
Loading...