129
UNITY MOTORHOME MOTORHOME MAINTENANCE
5
Refer to the detailed operating and safety
instructions in the Motorhome Information
Kit before performing the stabilizer override
procedure.
NOTICE
Stabilizer force can be adjusted using the stabilizer
control module
6
(location varies depending on
oor plan) (U24IB/TB located under passenger's
side dinette, U24MB/CB/FX located behind breaker
panel).
6
Periodically lubricate the stabilizer jack worm gears
7
with silicone spray to ensure consistent performance�
7
13� Open valve
D
(leave valve open after clearing
the system with compressed air).
14� Remove air supply chuck.
15� Wait until winterizing uid is leaving the drain line.
Collect escaping uid in a suitable container.
16� Close valve
D
after winterizing uid is seen.
MAINTENANCE AND SERVICING
LP GAS TANK VALVE
If the electrically operated LP Gas valve
3
(located
underneath the motorhome) fails to operate the LP
Gas tank, manually turn the valve clockwise to shut
off the LP Gas supply�
3
STABILIZERS
If the electrically operated stabilizers
4
fail to
operate, manually operate the override coupler
5
(located underneath the motorhome) to raise or
lower stabilizer units.
4
To Next Page
Loading...