71
UNITY MOTORHOME APPLIANCE AND EQUIPMENT OPERATION
LEISURE LOUNGE PLUS
SYSTEM (OPTIONAL)
LOWERING THE MURPHY BED
1� Refer to the "Slide Out Room" section in the
“Motorhome Operation” section for details.
2� Raise the table
1
, secure in upright position with
latch
3
and fold support/small table
2
�
1
2
3
3� Ensure lounge chairs are in the fully upright position
using recliner buttons
4
on the side of the chair�
4
5
4� Rotate lounge chairs so they are facing away
from bed by lifting and holding the lock button
5
while you swivel the seat. Release the lock
button when the chair is slightly rotated to ensure
the seat locks into the next position.
5� Remove the lounge chair seat back cushions
and headrests and fold the seat backs forward
until they lay at
6
�
6
6� Release the locks on both sides of the Murphy bed
(rotate to unlock).
7� Slowly and carefully lower the Murphy bed.
Ensure the Murphy bed locks into place once
fully lowered by lifting slightly on the side of the
bed. If bed is not locked, sit on corner of bed to
apply additional downward pressure�
8� Lower step cover
7
. Refer to the "Step Cover"
section in the “Motorhome Operation” section for
details�
7
Lower the step cover when lounge chairs
are in recliner mode
7 to prevent tripping
accidents. Refer to the "Step Cover" section
in the “Motorhome Operation” section of
this manual for detailed instructions.
CAUTION
To Next Page
Loading...