5.4101.8538.0 B
Installation 5-7
Installation
1. Use a pen to mark the installation height on the pillar (see figure 4 on page 5-3).
2. Install the nuts (1) and washers (3) on the tube clips (2) and turn the nuts (1) to the end of the thread
(see figure 7 on page 5-8).
3. Install the filling pieces (1) on the frame (2) (see figure 8 on page 5-9).
Potential falling object.
Risk of personal injury.
Always ware safety shoes and stand clear from the machine part during
installation.
4. Adjust the top of the frame (3) to the mark on the pillar (see figure 9 on page 5-10).
5. Install the frame (3) with the tube clips (4), washers (2) and nuts (1).
in n o vato rs in ag ric u lt u re
To Next Page
Loading...
