5.4101.8538.0 B
5-14 Installation
5.4 Install the Motor Housing
Installation
Heavy parts.
Risk of personal injury.
This procedure must be done by two persons.
Potential falling object.
Risk of personal injury.
Always ware safety shoes and stand clear from the machine part during
installation.
Pinch point.
Moving parts can crush or cut.
Keep hands clear.
Unexpected cow movement.
Risk of being crushed or trampled.
Block the cow traffic.
1. Apply copper grease to the motor housing shaft (3) (see figure 12 on page 5-15).
2. Install the motor housing (1) on the frame (2).
3. Make sure the motor housing has no clearance (A) and tighten the two screws (1) (see figure 13 on
page 5-16).
4. Tighten the two screws (1) (see figure 14 on page 5-17).
5. Install the washer (2), the spring washer (3) and the bolt (4).
in n o vato rs in ag ric u lt u re
To Next Page
Loading...
