5.4101.8538.0 B
5-18 Installation
Installation
Unexpected cow movement.
Risk of being crushed or trampled.
Block the cow traffic.
Pinch point.
Moving parts can crush or cut.
Keep hands clear.
If you fix the power cable to the wall, make sure there is enough cable
length to open the cover.
1. Install the box (2) to the frame (1) (see figure 15 on page 5-19).
2. Install the grounding cable (3) with the spring washer (2) and nut (1) to the frame (4) (see figure 16 on
page 5-20).
3. Guide the nut (3) over the motor cable (1) (see figure 17 on page 5-21).
4. Apply loctite 5331 to the thread of the cable hose (4).
5. Install the cable hose (4) to the box (2) and tighten the nut (3).
6. Connect the motor cable connector (1) to the box (2).
7. Torque tighten the motor cable connector (1) with the torque tool.
8. Guide the inductive sensor cable connector (2) through the frame (1) (see figure 18 on page 5-22).
9. Connect the inductive sensor cable connector (2) to the box (3).
10. Torque tighten the inductive sensor cable connector (2) with the torque tool.
In the USA/Canada (115V) the connection of the machine from the junction
box to the power network must be made by a certified electrician (see page
5-24).
11. Install the power cable (1) with the strain relief (2) (see figure 19 on page 5-23).
12. Squeeze the strain relief with a pipe wrench on the cable.
13. Connect the power cable connector (1) to the box (4).
in n o vato rs in ag ric u lt u re
To Next Page
Loading...
