5.4101.8538.0 B
Maintenance 7-3
1. Remove the bolt (4), washer (3) and buffer washer (2) (see figure 22 on page 5-27).
2. Remove the brush (1).
3. Examine the brush (1). If necessary:
• Clean the brush with water.
• Place the worn side of the brush to the motor housing side or
• Replace the brush.
Installation
1. Install the brush (1).
2. Apply loctite 243 to the bolt (4).
3. Install the buffer washer (2), washer (3) and the bolt (4).
4. Torque tighten the bolt (4) to 65±5 Nm.
Close-up
1. Connect the machine to the power supply.
2. Unblock the cow traffic.
in n o vato rs in ag ric u lt u re
To Next Page
Loading...
