4.2 Adjust the Ground Pressure
1. Stop the tractor engine.
Wait until all moving parts have stopped before you do adjustments to
the Splendimo.
2.
Turn the ball valve counterclockwise to release the pressure from the
hydraulic system (fig. 15, page 4-2).
3. Operate the hydraulic system until the pressure gauge shows the correct
pressure.
4. Turn the ball valve clockwise to close the hydraulic system.
5. Set the hydraulic valve in the tractor to the floating position.
On flat ground a pressure of 75 bar (7.5 MPa) is correct.
The ground pressure setting does not change when you lift the mower
to the headland or transport position.
The hydraulic pressure setting does not change if the ball valve stays
closed.
Figure 15. Hydraulic Pressure Gauge and Ball Valve
WARNING
Note:
Note:
Note:
4-2 Test and Adjustment
M-H026.1004EN
To Next Page
Loading...