LELY Splendimo 320 M - 1.4 Optional Extras Lely Splendimo 320 M

The ground-pressure relief system makes sure the cutter bar follows the
ground contours without damaging the crop and transfers some of the
Splendimo weight to the tractor.
It can be adjusted by regulating the pressure of the hydropneumatic spring
system.
1.4 Optional Extras Lely Splendimo 320 M
1.4.1 Wear Plates
Wear plates can be installed on the bottom of the skids to reduce wear of the
skids. The wear plates are available in thicknesses of 4 mm or 8 mm.
1. Wear plate - 2. Topping skid
Figure 2. Wear Plate and Topping Skid
1.4.2 Topping Skids
Topping skids can be installed on the bottom of the skids to raise the mowing
height
approximately 3 cm. This is used for topping or when the mower is used
on rough ground, and reduces damage to the cutter bar by stones and other
debris.
If topping skids are installed, position 2 or 3 of the parking jack must be used
(fig. 9, page 3-4).
1.4.3 Agitators
Agitators can be installed on the mower discs to improve the crop flow across
the cutter bar in certain circumstances.
Figure 3. Agitator
1.4.4 Crop Divider
A crop divider pushes the crop that has not been mown to the side of the mower
and prevents an accumulation of grass on the mower.
This is useful when the crop is extremely long or when the crop lies down.
Introduction 1-3
M-H026.1004EN