5.3.5 Assemble the Cutter Bar
• Requirements:
•
Socket spanner 46 mm
• Torque wrench
• 150 cm extension pipe
• Castrol Tarp or equivalent
• Molykote BR2 Plus or equivalent
• Molykote P74 or equivalent
1. Clean:
• The centring rings (8)
• The contact areas of the mower elements (10) and the intermediate
spacers (9).
2. Make sure there is no dirt between all the contact areas.
3. Rub the contact areas of the mower elements and intermediate spacers
with Castrol Tarp or equivalent.
4. Grease the drive shaft (5) with Molykote BR2 Plus or equivalent.
5. Turn the mower disc (2) 90° in relation to the adjacent mower disc.
6. Install the mower elements and the intermediate spacers according to
the direction of rotation of the mower elements.
7. If a mower element cannot be installed on the drive shaft:
• Turn the mower disc several half turns until the element can be
installed.
8. Install the securing plug (11) and locking ring (12) in the outer mower
element.
9. Install the end plate (19).
10. Grease the M30 nut (16), the ring (17) and the treaded part of the
connecting rod (20) with Molykote P74 or equivalent.
11. Install the ring (17).
12. Tighten the M30 nut (16).
13. Put the cutter bar under the mower.
14. Put the yoke (4) in line with the stub axle (3) of the gearbox (2).
15. Carefully lower the Splendimo.
16. Make sure the stub axle of the gearbox moves in the yoke.
17. On both sides of the Splendimo:
1. Make sure the five holes of the end plate are in line with the five
holes at the bottom of the support.
2. Tighten the five bolts (18) fingertight.
3. Torque-tighten the five bolts (18) to 120 Nm (12 Kgm).
4. Install a second nut (locknut) on each of the five bolts (18).
18. Extend the Torque wrench with the 150 cm extension pipe.
19. Torque-tighten the M30 nut (16) to 950 Nm (95 Kgm).
20. Tighten the M30 (16) nut until the securing plate (13) can be installed.
5-16 Maintenance
M-H026.1004EN
To Next Page
Loading...