LELY Splendimo 320 M - Disassemble the Cutter Bar

5.3.4 Disassemble the Cutter Bar
• Requirements:
•
Socket spanner 46 mm
• Torque wrench
• 150 cm extension pipe
1. Clean the cutter bar.
2. Connect the Splendimo to the tractor (page 3-1).
3. Lower the Splendimo onto a level floor.
4. Remove the securing plate (13).
5. Extend the Torque wrench with the 150 cm extension pipe.
6. Use the torque wrench to loose the M30 nut (16). Do not remove the
nut.
7. On both sides of the cutter bar:
• Remove the five bolts (18) from the bottom of the support.
8. Remove the cutter bar.
9. Remove the M30 nut (16) and the ring (17).
10. Remove the end plate (19).
11. Remove the mower elements (10), and the intermediate spacers (9),
from the connecting rod (20).
5-14 Maintenance
M-H026.1004EN