Operation
52
11.8 Skimmers
11.8.1 General
The skimmers (1) should penetrate ap-
proximately 5 - 10 cm deep into the soil
and, when viewed from above, should ex-
tend approximately 2 - 3 cm beyond the
side of the share line.
11.8.2 Working depth
Loosen the bolts (2).
Set the skimmers (1) to the depth re-
quired.
Tighten the bolts (2), see «Tightening
torques, page 65».
11.8.3 Adjusting the projection angle
Loosen the bolts (2).
Move the skimmers (1) to the angle re-
quired.
Tighten the bolts (2), see «Tightening
torques, page 65».
Check the lateral position, see «Lateral
position, page 53».
»»
1
1
2
1
2
To Next Page