LEMKEN Opal 090 B - Put the implement out of operation; Shutting down the implement in an emergency; Disposal

Operation
58
11.12 Working depth adjustment
Adjust the working depth using the screw
(3).
 Turn the screw (3) to make it shorter
=> increases working depth
 Turn the screw (3) to make it longer
=> reduces working depth
If the adjustment range of the screw is in-
adequate, the working depth can also be
set using the bolts (4).
 Turn the bolts (4) to make them shorter
=> increases working depth
 Turn the bolts (4) to make them longer
=> reduces working depth
Ensure that both bolts (4) are set to the
same length.
4
2
3