LENCO Auto Glide - Default Chapter; Table of Contents

1.0 PRODUCT OVERVIEW
TABLE OF CONTENTS
...3-4
...5-6
...5
...6
...5
...6
...6
...7
...8
...7-11
2.0 MECHANICAL INSTALLATION
TM
AUTO GLIDE
TM
2.1 Auto Glide Key Pad Installation
2.2 Replacing Existing 123 LED Indicator / 124 Standard Key Pad
TM
2.3 Auto Glide Control Box Installation
TM
2.4 Optional Auto Glide Control Box Mounting Bracket Installation
2.5 Replacing Existing 123 / 123DR LED Indicator / 124 Standard Control Box
3.0 ELECTRICAL INSTALLATION
TM
AUTO GLIDE
TM
3.1 Auto Glide Control Box Harnesses Overview
TM
3.2 Auto Glide Control Box Harness Installation
...9
...9-10
...11
...11
3.3 Battery Switch Requirements
3.4 Optional GPS (Stand Alone) Antenna Installation
TM
3.5 Optional Auto Glide GPS Mounting Bracket
TM
3.6 Auto Glide Second Station Kit Installation
...12-14
...12
...12
...13-14
...14
4.0
TM
AUTO GLIDE INSTALLATION VERIFICATION
...15-19
...15
...15-17
...17-19
5.0 HOME ROLL AND HOME PITCH SETUP INSTRUCTIONS
TM
4.1 Auto Glide Test Mode
4.2 Testing The Trim Tab Actuators
4.3 CANBUS Data Verification
4.4 Exiting Test Mode
5.1 Home Roll and Home Pitch Overview
5.2 Home Roll Setup
5.3 Home Pitch Setup
...4
1.1 System Requirements
2
Rev 03-10-11
AUTO GLIDE
...20-22
...20-21
...21-22
6.0 RESETTING HOME ROLL AND HOME PITCH DEFAULT POSITIONS
6.1 Resetting Home Pitch Only
6.2 Resetting Home Roll and Pitch