47
End Advanced Diagnostics Access
1. Press the Advanced Diagnostics in progress icon/badge.
The Advanced Diagnostics in progress dialog displays.
2. Press End Access to disconnect the communication between the dealer/
technician and the thermostat.
The End Advanced Diagnostics Access? dialog displays.
3. Press Yes.
The Remote Access has been canceled dialog displays.
4. Press OK.
The Advanced Diagnostics Access Canceled badge/icon displays on the
thermostat’s home screen.
NOTE: If the homeowner attempts to end Advanced Diagnostics Access
while a dealer/technician is diagnosing the homeowner’s system,
disconnection will not be immediate. Access ends after the service/
diagnostics is complete.
If the homeowner decides to end access before the dealer/technician
connects to their system, the dealer/technician will not gain access to
the homeowner’s thermostat.
FCC Statements
FCC Compliance Statement — PART 15.19
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
» This device may not cause harmful interference, and
» This device must accept any interference received, including
interference that may cause undesired operation.
FCC Interference Statement — PART 15.105 (B)
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:
» Reorient or relocate the receiving antenna.
» Increase the separation between the equipment and receiver.
» Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
» Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Information
This device meets the FCC and ISED requirements for RF exposure in public
or uncontrolled environments.
Canada License-Exempt RSS Standard(s) Operation
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
» This device may not cause interference, and
» This device must accept any interference, including interference that
may cause undesired operation of the device.
Changes or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
To Next Page
Loading...
Need help?
General
