Lenovo S3200 - Disk Group and Volume Management

18 Components
Figure 8 shows CNC ports configured with 1 Gb RJ-45 SFPs.
Figure 8 S2200 CNC controller module face plate (1 Gb RJ-45)
NOTE: See CNC ports used for host connection on page 10 for more information about CNC technology. For
CNC port configuration, see the “Configuring host ports” topic within the Storage Manager Guide or online
help.
S2200 SAS controller module — rear panel components
Figure 9 shows host interface ports configured with 12 Gbit/s HD mini-SAS (SFF-8644) connectors.
Figure 9 S2200 SAS controller module face plate (HD mini-SAS)
1 CNC ports used for host connection
(see Install an SFP transceiver on page 80)
2 CLI port (USB - Type B) [see Appendix D]
3 Service port 2 (used by service personnel only)
4 Reserved for future use
5 Network port
6 Service port 1 (used by service personnel only)
7 Disabled button (used by engineering only)
(Sticker shown covering the opening)
8 mini-SAS expansion port
CACHE
CLI
CLI
LINK
ACT
6Gb/s
SERVICE−1SERVICE−2
PORT 0 PORT 1
5
2 3 6 8
1
7
4
= FC LEDs
= 1Gb iSCSI LEDs (both CNC ports use 1 Gb RJ-45 SFPs in this figure)
1 HD mini-SAS ports used for host connection
2 CLI port (USB - Type B) [see Appendix D]
3 Service port 2 (used by service personnel only)
4 Reserved for future use
5 Network port
6 Service port 1 (used by service personnel only)
7 Disabled button (used by engineering only)
(Sticker shown covering the opening)
8 mini-SAS expansion port
CACHE
CLI
CLI
LINK
ACT
6Gb/s
SERVICE−1SERVICE−2
ACT
LINK
ACT
LINK
SAS 0 SAS 1
12Gb/s
5
2 3 6 8
1
7
4