80 SFP option for CNC ports
E SFP option for CNC ports
Locate the SFP transceivers
Locate the qualified SFP options for your CNC controller module within your product ship kit. The SFP
transceiver (SFP) should look similar to the generic SFP shown in the figures below.
Figure 49 Install a qualified SFP option into an S3200 CNC controller module
Figure 50 Install a qualified SFP option into an S2200 CNC controller module
Install an SFP transceiver
For each target CNC port, perform the following procedure to install an SFP. Refer to the appropriate figure
above when performing the steps.
Follow the guidelines provided in Electrostatic discharge when installing
an SFP.
PORT 1
CACHE
LINK
DIRTY
LINK
ACT
CLI
CLI
SERVICE−2
SERVICE−1
PORT 0
PO
RT 1
PORT 2
PORT 3
PORT 1
6Gb/s
Installed SFP
(actuator closed)
Target CNC port
Align SFP for installation
(plug removed/actuator open)
Controller module face plate
Fibre-optic interface cable
PORT 1
CACHE
LINK
DIRTY
LINK
ACT
CLI
CLI
SERVICE−2
SERVICE−1
PORT 0
PORT 1
PORT 1
6Gb/s
Installed SFP
(actuator closed)
Target CNC port
Align SFP for installation
(plug removed/actuator open)
Controller module face plate
Fibre-optic interface cable
To Next Page
Loading...
