Lenovo Storage S3200/S2200 Setup Guide 35
See the “Replacing a controller or expansion module” topic within the CRU Installation and Replacement
Guide for additional information about installing IOMs.
Dual-controller configurations
A dual-controller configuration improves application availability because in the event of a controller failure,
the affected controller fails over to the partner controller with little interruption to data flow. A failed
controller can be replaced without the need to shut down the storage system.
In a dual-controller system, hosts use LUN-identifying information from both controllers to determine that up
to four paths are available to a given storage volume. Assuming MPIO software is installed, a host can use
any available data path to access a volume owned by either controller. The path providing the best
performance is through host ports on the volume’s owning controller. Both controllers share one set of
1,024 LUNs (0-1,023) for use in mapping volumes to hosts (see “ULP” in the Storage Manager Guide).
The illustrations below show dual-controller configurations for S3200/S2200 controller enclosures
equipped with either CNC ports or 12 Gb HD mini-SAS host ports.
One server/one HBA/dual path
Figure 20 Connecting hosts: S3200 direct attach—one server/one HBA/dual path
Figure 21 Connecting hosts: S2200 direct attach—one server/one HBA/dual path
12Gb/s
S
S
A
6Gb/s
6Gb/s
S
S
A
S
S
A
12Gb/s
S
S
A
12Gb/s
S
S
A
12Gb/s
S
S
A
6Gb/s
6Gb/s
12Gb/s
S
S
A
12Gb/s
S
S
A
To Next Page
Loading...
