Lenovo Storage D1212 - Page 121

Unsuccessful
0
Device not ready
0
5+03:27:47.299 M1 GEM>
driveinv
This command shows a quick view of all drives, such as vendor, model, serial number, firmware version,
temperature, and capacity information.
Note: This command is supported on version 5.0.0.19 or later.
Syntax:
driveinv
Example:
2+15:08:09.151 M0 GEM> driveinv
Drive Vendor Model Serial
Rev Temp
Size
0 LENOVO ST1800MM0018 X S3Z0EFWW0000M642K6YY L59B 29 C 1800 GB
1 LENOVO ST1800MM0018 X S3Z0DTJB0000K6436TPH L59B 30 C 1800 GB
2 LENOVO ST1800MM0018 X S3Z0DKP40000M6434UTM L59B 30 C 1800 GB
3 LENOVO ST1800MM0018 X S3Z0DR270000M6431YPK L59B 28 C 1800 GB
exit
Terminates the current CLI session. When run over the serial port, this returns the user to the login prompt.
When run over telnet, the telnet session is terminated.
Usage:
exit
Example:
0+03:20:09.677 M0 GEM> exit
Login:
getboardid
Retrieves the identity and operating mode of the ESMs on which the command is executed.
Syntax:
getboardid [mode]
mode
When mode is set to “hex”the command output is provided as a
machine readable hexadecimal dump
Example:
0+03:24:40.474 M0 GEM> getboardid
Board ID: 0, Mode: master
getvpd
Displays inventory information for all populated enclosure FRUs.
Note: Canister is another term for ESM.
Chapter 7. GEM CLI Commands 101