19
Lenovo Converged HX Series Hardware Replacement Guide
© Copyright Lenovo 2017
Figure 16 illustrates the final boot order in the UEFI setup screen.
Figure 16. Boot Order
Configure M.2 Mirroring
The M.2 adapter must be configured with a RAID 1 mirrored virtual drive to allow the Hypervisor to be installed
for booting. Follow these steps from the UEFI setup screen:
System Settings > Storage > M.2 + Mirroring Kit Configuration Utility > [Configuration Management] > [Create
RAID Configuration] > [RAID Level] > Select RAID 1 > CREATE
To Next Page
Loading...
