18
Lenovo Converged HX Series Hardware Replacement Guide
© Copyright Lenovo 2017
Power performance bias
This option allows the OS (hypervisor) to control the node power. Many customers prefer this setting as it saves
on OPEX.
Use the ASU system tool, or other means, to set the power performance bias to “OS Controlled”:
>asu64 set Power.PowerPerformanceBias “OS Controlled”
Figure 15 shows where to change the setting using UEFI setup.
Figure 15. OS Controlled
Configure Boot Order
Use the ASU system tool, or other means, to configure the boot order as follows:
1.
CD/DVD Rom
2.
Hard Disk 0
3.
PXE Network
>asu64 set BootOrder.BootOrder=”Legacy Only=CD/DVD Rom=Hard Disk 0=PXE Network”
To Next Page
Loading...
