EasyManuals Logo

Lenovo ThinkPad S2 3rd Gen Hardware Maintenance Manual

Lenovo ThinkPad S2 3rd Gen
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
Turn an additional angle of 180 degrees after the screw head touches the surface of the logic card.
Notes:
Ensure that you use the correct screw. It is recommended to use new screws for replacements. If you
have a torque screwdriver, tighten all screws firmly to the torque specified in the screw information table
for each step.
Ensure torque screwdrivers are calibrated correctly following country specifications.
Retaining serial numbers
This topic provides instructions on the following:
“Restoring the serial number of the system unit” on page 70
“Retaining the UUID” on page 71
Restoring the serial number of the system unit
When the computer was manufactured, the EEPROM on the system board was loaded with the serial
numbers of the system and all major components. These numbers need to remain the same throughout the
life of the computer.
If you replace the system board, you must restore the serial number of the system unit to its original value.
The serial number of the system unit is written on the label attached to the bottom of the computer.
If you can not find the serial number of the system unit on the bottom of the computer, try the following
method to get the number:
Note: Before you perform the operation, ensure that the UEFI/Legacy setting within the Startup menu in the
ThinkPad Setup program is set to UEFI Only.
1. Connect a USB memory key to the computer.
2. Go to
http://www.lenovo.com/maintenanceutilities and follow the instructions on the screen to create a
Maintenance key.
Note: Only an authorized Lenovo service technician can access the above Web site.
3. Restart the computer.
4. When the logo is displayed, press Esc. The ThinkPad Config Information Update Utility interface is
displayed.
5. Type 1 under Enter the action desired, then press Enter. The ThinkPad Serial Number Update Utility for
Asset ID screen is displayed.
6. Type 2 under Enter the action desired, then press Enter. The serial number of each device in your
computer is displayed; the serial number of the system unit is listed as follow:
20- Serial number
7. Record the serial number of the system unit.
70
L380, L380 Yoga, S2 3rd Gen, and S2 Yoga 3rd Gen Hardware Maintenance Manual

Table of Contents

Other manuals for Lenovo ThinkPad S2 3rd Gen

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lenovo ThinkPad S2 3rd Gen and is the answer not in the manual?

Lenovo ThinkPad S2 3rd Gen Specifications

General IconGeneral
BrandLenovo
ModelThinkPad S2 3rd Gen
CategoryLaptop
LanguageEnglish

Related product manuals