11.Useaflatscrewdrivertoremovethetwohexagonalscrews1thatsecuretherearofthesystem
boardtothechassis.
Figure77.Removingthetwohexagonalscrewsthatsecuretherearofthesystemboard
12.Gentlylifteachedgeofthesystemboardslightlyupwardsothatthesystemboardisreleasedfrom
themountingstudsonthechassis.Then,movethesystemboardtothefrontoftheserverandthen
carefullypivotthesystemboardupwardtoremoveitoutofthechassis.
Notes:
•Carefullyhandlethesystemboardbyitsedges.
•LeavetheblackMylarundertheoldsystemboardinthechassis.
13.Placetheoldsystemboardonaclean,flat,andstatic-protectivesurface.Touchthestatic-protective
packagethatcontainsthenewsystemboardtoanyunpaintedsurfaceontheoutsideoftheserver.
Then,takethenewsystemboardoutofthepackage.
14.Installthenewsystemboardintothechassis.Ensurethattherearconnectorsonthenewsystemboard
areinsertedintothecorrespondingholesintherearpanel.Ensurethattheeightscrewholesinthenew
systemboardarealignedwiththecorrespondingmountingstudsonthechassis.
Chapter6.Installing,removing,orreplacinghardware103
To Next Page
Loading...
