Lenovo ThinkServer TS140 70A0 - Replacing the Primary Hard Disk Drive

9.ConnectoneendofthesignalcabletotheharddiskdriveandtheotherendtoanavailableSATA
connectoronthesystemboard.See“Locatingpartsonthesystemboard”onpage17
.Then,locatean
availablefive-wirepowerconnectorandconnectittotheharddiskdrive.
Figure52.ConnectingaSATAharddiskdrive
Replacingtheprimaryharddiskdrive
Attention:Donotopenyourserverorattemptanyrepairbeforereadingandunderstanding“Safetyinformation”
onpageiiiand“Guidelines”onpage39.
Thistopicprovidesinstructionsonhowtoreplacetheprimaryharddiskdrive.
Note:Fora2.5-inchharddiskdriveorsolid-statedrive,installthedriveintoa3.5-inchto2.5-inchdrive
adapterfirst.See“Installingthe2.5-inchsolid-statedriveorharddiskdrive”onpage49
.
Toreplacetheprimaryharddiskdrive,dothefollowing:
1.Removeallmediafromthedrivesandturnoffallattacheddevicesandtheserver.Then,disconnectall
powercordsfromelectricaloutletsanddisconnectallcablesthatareconnectedtotheserver.
2.Removetheservercover.See“Removingtheservercover”onpage41.
3.Locatetheprimaryharddiskdrive.See“Locatingpartsonthesystemboard”onpage17.
4.Disconnectthesignalcableandthepowercablefromtherearoftheharddiskdrive.
72ThinkServerTS140HardwareMaintenanceManual