Figure 107. Memory module locations
Complete the following steps to remove a memory module.
Watch the procedure. A video of the replacement process is available:
•
YouTube
• Youku
Step 1. Open the memory module connector retaining clips to extract the memory module; then, remove
the memory module.
If you are not replacing the memory module that you removed:
1. See the ThinkSystem SR950 Memory Population Reference for the required installation order of the
remaining memory modules.
2. Install a memory module filler, that was originally provided with the PHM option, in any vacant memory
module connectors.
3. Install the upper system board or system board filler, if it was removed. See “Install a system board” on
page 310.
4. Install the compute tray where the system board is installed. See “Install a compute tray” on page 307.
354
ThinkSystem SR950 Setup Guide
To Next Page
Loading...
