5. Install the front cover. See “Install the front cover” on page 322
If you are instructed to return the memory module, follow all packaging instructions and use any packaging
materials that are provided.
Install a memory module
Memory modules are in the system boards that are accessed from the front of the server.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
See “Memory module installation rules and order” on page 58 for detailed information about memory
configuration and setup.
“
” on page 56 “ ” on page 254 “
” on page 57
CAUTION:
Make sure that all server power cords are disconnected from their power sources before performing
this procedure.
Note: The same procedure is used to install memory modules and memory module fillers.
Figure 108. Memory module locations
Appendix B. Component reference 355
To Next Page
Loading...
