Note: In this illustration, the image on the left shows the tray right-side up and the image on the right shows
the tray upside down.
Figure 17. Cable routing, common drive cables (upper tray with storage-board assembly)
Table 40. Cable routing, common drive cables (upper tray)
Cable
Routing
1 Power to drive
backplanes 4, 5, and 6
• From: Storage interposer (see “Storage interposer connectors” on page 289)
– For drive backplane 4, use interposer “BP 3/4” connector
– For drive backplane 5, use interposer “BP 2/5” connector
– For drive backplane 6, use interposer “BP 1/6” connector
• To: Drive backplane, connector “Power” (see “Drive backplane connectors” on page
291)
2 RAID flash power
module
• From: RAID flash power module connector
• To: RAID card, flash power module (J14) connector (see “RAID card connectors” on
page 290)
46 ThinkSystem SR950 Setup Guide
To Next Page
Loading...
