Table 40. Cable routing, common drive cables (upper tray) (continued)
Cable
Routing
3 Drive power
• From:
– Lower system board in upper compute tray, “POWER” connector (see “System-
board connectors” on page 283)
– Storage-board assembly in upper tray, hard disk drive power (J2) connector (see
“Storage-board-assembly connectors” on page 284)
• To: Storage interposer, “POWER” connector (see “Storage interposer connectors” on
page 289)
4 Drive signal
• From:
– Lower system board in upper compute tray, “Signal” connector (see “System-
board connectors” on page 283)
– Storage-board assembly in upper tray, hard disk drive signal (J13) connector (see
“Storage-board-assembly connectors” on page 284)
• To: Storage interposer, “SIDEBAND” connector (see “Storage interposer connectors”
on page 289)
SAS drive cables (upper tray)
Common drive cables are used by only SAS drives.
Note: In this illustration, the image on the left shows the tray right-side up and the image on the right shows
the tray upside down.
Figure 18. Cable routing, SAS drive cables (upper tray with system board)
Chapter 2. Server components 47
To Next Page
Loading...
