Figure 73. Loosening the screws on the heat sink and fan module for processor with TDP lower than 95W
Loosening the screws on the heat sink and fan module for processor with 95W TDP
Figure 74. Loosening the screws on the heat sink and fan module for processor with 95W TDP
Step 5. Evenly lift the heat sink and fan module, and remove it from the system board.
After you finish
1. If applicable, install a new heat sink and fan module, see
“Install the heat sink and the fan module
(trained technician only)” on page 96.
Chapter 3. Hardware replacement procedures 95
To Next Page
Loading...
