Lenovo ThinkSystem ST50 V2 Maintenance Manual

Figure 104. Removing the processor
After you finish
After removing the processor, perform one of the following tasks immediately:
• Install the replacement processor.
1. Install the replacement processor to the system board, see
“Install the processor (trained technician
only)” on page 135
.
2. Package the defective processor that was removed, and return it to Lenovo. To prevent any shipping
damage, reuse the packaging of the new processor, and follow all available packaging instructions.
or
• Install the processor that you removed to the replacement system board.
1. Install the removed processor to the replacement system board, see
“Install the processor (trained
technician only)” on page 135
.
2. Package the defective system board, and return it to Lenovo. To prevent any shipping damage, reuse
the packaging of the new system board, and follow all available packaging instructions.
Install the processor (trained technician only)
Follow this procedure to install the processor. This procedure must be executed by a trained technician.
Chapter 3. Hardware replacement procedures 135

Lenovo ThinkSystem ST50 V2 Specifications

General

Memory	Up to 128 GB DDR4
Memory Slots	4 DIMM slots
Form Factor	4U Tower
Processor	Intel Xeon E-2300 series
Storage	Up to 4 x 3.5" or 8 x 2.5" drives
Storage Controller	Onboard SATA controller
RAID Support	RAID 0, 1, 5, 10
Expansion Slots	1x PCIe 3.0 x4
Network	1x Gigabit Ethernet port
Operating Systems Supported	Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi
Management	Lenovo XClarity Controller