Figure 108. Removing the screws on the front of the rack cabinet
Step 2. Remove the server from the rails.
a.
Slide and pull the rack server tray out of the rack cabinet.
b.
Lift the server out of the tray.
Figure 109. Removing the server from the rails
After you finish
1. Place the server on its side with the cover up.
2. To install the server to the rails, see
“Install the server to the rails” on page 139.
Install the server to the rails
Follow this procedure to install the server to the rails.
Chapter 3. Hardware replacement procedures 139
To Next Page
Loading...
