Install the power button with LED
Follow this procedure to install the power button with LED.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
About this task
Attention:
1. Read
“Safety inspection checklist” on page iv and “Installation guidelines” on page 41 to ensure that you
work safely.
2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
AU3iY3F7lq3qfqr5caGbIu
.
Procedure
Step 1. Install the power button with LED.
a.
Tilt the power button, and insert the tab on the bottom of the power button cable into the
slot.
b.
Push the power button into the slot until it snaps into place.
Figure 99. Installing the power button with LED
Step 2. Reinstall the front panel, see “Install the front panel” on page 90.
Step 3. Connect the power button cable to the system board, see “Internal cable routing” on page 19.
Chapter 3. Hardware replacement procedures 127
To Next Page
Loading...
