Figure 114. Securing the tray with screws
After you finish
Proceed to complete the parts replacement, see
“Complete the parts replacement” on page 158.
Server cover replacement
Follow this procedure to remove and install the server cover.
Remove the server cover
Follow this procedure to remove the server cover.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Chapter 3. Hardware replacement procedures 143
To Next Page
Loading...
