Figure 50. Installing the EMI shielding
Step 2. Make sure there is no optical drive installed on the optical drive cage. Then, istall the 3.5-inch drive
cage to the optical drive cage.
a.
Align the four hooks on the optical drive cage with the corresponding hooks on the 3.5-inch
drive cage; then, lower the optical drive cage onto the 3.5-inch drive cage, and slide the optical
drive forward until it secures into place.
Note: Make sure the four hooks on both drive cages are fully engaged.
b.
Fasten the captive screw to secure the two drive cages together.
Figure 51. Installing the 3.5-inch drive cage to the optical drive cage
Chapter 3. Hardware replacement procedures 69
To Next Page
Loading...
