Figure 60. Removing the optical drive cage
After you finish
1. If applicable, replace the 3.5-inch drive cage or replace the 3.5-inch drive, see
“Simple-swap drive and
drive cage replacement (bay 3)” on page 62
.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install the optical drive cage
Follow this procedure to install the optical drive cage.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Chapter 3. Hardware replacement procedures 77
To Next Page
Loading...
