1. Read “Safety inspection checklist” on page iv and “Installation guidelines” on page 41 to ensure that you
work safely.
2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
AU3iY3F7lq3qfqr5caGbIu
.
Procedure
Step 1. Install the front panel.
a.
There is a small tab on the right side of the front panel. Place the tab behind the front panel
slot on the chassis.
b.
Align the guide hole and screw hole on the front panel with the guide pin and screw slot on
the chassis; then, install the front panel to the chassis.
Note: Make sure the small tab on the right side of the front panel is placed behind the chassis.
Figure 70. Installing front panel to chassis
Chapter 3. Hardware replacement procedures 91
To Next Page
Loading...
