Lenze 4800 - Page 337

Index
18-7
48XX/49XXSHB0399
Parameter setting, 7-33
Monitoring functions, 7-96
Change, 7-96
Display priority, 7-98
I(2)xt monitoring, 7-101
Ixt monitoring, 7-100
Message, 7-97
Possible assignments, 7-97
Trip, 7- 96
Warning, 7-96
Monitoring functions
Following error, 7-54
Phase controller limit, 7-53
Motor
Armature time constant, 7-14
Armature time constants, 5-4
Blocking protection, 7-103
Checking, 8-7
Connection, 4-5
Motor data input, 5-4
Overload monitoring, 7-101
Voltage limitation, 7-16
Motor potentiometer, 7-73
Control, 7-74
Deactivation function, 7-74
Memory function, 7-75
N
Networking, Accessories, 13-15
Noise immunity, 3-3
O
Offset
Adjustment of analog inputs, 7-19
Adjustment of monitor outputs, 7-33
Speed synchronism, 7-51
Operating unit, 7-109, 7-118
Operating modes, 7-116
Operation
Control mode 4Q/2Q, 7-60
Operating state, 12-1
Speed controlled operation, 7-1
State, 7-126
Torque controlled, 7-37
With host connection , 4-26
Operator’s safety, 4-2
Optical fibres, 13-15
Outputs
Analog, 4-16
Delay time, 7- 24
Digital, 4-19
FDO, 7- 24
Freely assignable analog, 7-33
Freely assignable digital, 7-24
Freely assignable, analog, 5-10
Freely assignable, digital, 5-9
Fuse monitoring, 4-20
Relay, 4-20
Overload
Controller, 7-100
Monitoring, 7-101
Motor, 7-101
Overtemperature, 7-126
P
Parameter, 7-110
Change, 7-111
Channel, 12-3
Fault, 7-97
Input selection, 7- 113
Parameter level, 7-110
Parameter set
Change, 7-57
Dancer position control, 7-59
Load, 7-58, 7-114
Store, 7-114
Parameter setting, 7-108
Password protection, 7-115
Peripherals
Interface module 2110IB, 4-27
Interface module 2130IB, 4-28
Level converter 2101IB, 4-26
Phase
Controller, 7-53
Controller limit, 7-53
Synchronisation, 7-52
Trimming, 7-54
Show/Hide Bookmarks