Lenze 4800 - Page 338

Index
18-8
48XX/49XXSHB0399
Power connection, Standard controller,
4-6
Power derating, 3-1
Process controller, 7-67
Inputs, 7- 68
Outputs, 7-69
Process data channel, 12-3
PROFIBUS, 12-3
Enable, 12-3
PT1 element, 7-80
Pulse inhibit
Change of the monitoring, 7-96
Message, 8-2
Q
QSP, 5-6
Qualified personnel, 2-2
Quick stop, 4-19, 5-6
Brake control, 7-62
Code set, 7-123
Possible configuration, 5-7
With activated phase controller, 7-53
R
Ramp function generator, 7-2, 7-68
Additional set-value, 7-2
Main set- value, 7-2, 7- 6
Motor potentiometer, 7- 74
Process controller, 7-67
S-shaped, 7-94
Rated data, 3-4
Armature voltage, 3-4, 7- 60
Ratio, 7-123
RDY, 7-109, 8-2
Ready for operation, Message, 8-2
Redundant actual value feedback, 7-55
Relative humidity, 3-3
Relay output, 4-20
Reset, Fault indication, 8-6
Residual hazards, 2-3
Resolver, 4-21, 7-13
Encoder emulation, 4-25
Rotor position, 7-54, 7-124
RS232/485, 4-26, 12-1
S
S&H (Sample and Hold), 7-75
S-shaped ramp function generator, 7-94
Safety information
General, 2- 3
Icons, 2-4
Scope of delivery, 1-1
Screening
Control and signal cable, 4-3, 4-31
Power connections, 4-30
Set-value
Additional set-value, 7-2
Bar, 7-42
Cascade, 7-46
Digital frequency coupling, 7-39
FIXED set-values, 7- 77
Gain adjustment, 7- 19
JOG, 7- 2
Limitation, 7-9, 7-11
Main set- value, 7-2
Master current, 7-4
Motor potentiometer, 7- 73
Process controller, 7-67, 7-68
Selection, 7-1
Setting range, 7-14
Torque control, 7-37
Torque set-value, 7- 89
Setting range
Current, 3-1
Speed, 14-4
Signal-flow chart
Armature current limitation, 7-90
Speed set-value selection, 7- 1, 7-9
Torque control, 7-38
Vdown control, 7-18
Vdown limitation, 7-17
Signal-flow charts, 16-1
Show/Hide Bookmarks