Lenze 8210 HVAC Series - Code Table

Configuration
7-2 821XKlimaBA0399
7.2 Code table
How to read the code table:
Column Abbreviation Meaning
Code C013 Code C013
- The parameter of the code can be different in PAR1 and
PAR2.
- The parameter value is accepted immediately (ONLINE).
C009* - The parameter value of the code is always the same in
PAR1andPAR2,butisalwaysdisplayedinPAR1.
C001 ¤ - The parameter value of the code will be accepted after
pressing SH+ PRG.
[C002] - The parameter value of the code will be accepted after
pressing SH+ PRG but only if the controller is inhibited.
Name
820X
Name of the code.
Unit-specific setting possibilites (here for 820X).
Without unit designation the code is valid for all unit types.
Lenze Factory setting of the code
* The column ”Important” contains further information
Selection 1{1%}99Min. value {Steps/Unit} Max. Value
Info - Meaning of the code
IMPORTANT - Additional, important explanation of the code
Show/Hide Bookmarks