Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Display elements and function keys
2
14
EDKVF93−05 EN 1.0
Displays
Display Meaning Explanation
Status displays of standard device
Ready for operation
Pulse inhibit is active Power outputs are inhibited
Set current limit is exceeded in motor or
generator mode
Speed controller 1 in its limitation Drive is torque−controlled
(Only active for operation with standard devices
of 9300 series)
Active fault
Parameter acceptance
Parameter is accepted immediately Standard device operates immediately with the
new parameter value
SHPRG Parameter must be confirmed with
Standard device operates with the new parameter
value after being confirmed
SHPRG When the controller is inhibited the
parameter must be confirmed with
Standard device operates with the new parameter
value after the controller is re−enabled
None Display parameter Change is not possible
Active level
Menu Menu level is active Select main menu and submenus
Code Code level is active Select codes and subcodes
Para Parameter level is active Change parameters in the codes or subcodes
None Operating level is active Display operating parameters
Short text
Alphanumeric Contents of the menus, meaning of the
codes and parameters
In the operating level C0004 (in %) and
the active fault are displayed
Number
Menu level With active level:
Menu number
Only active for operation with standard devices of
8200 vector or 8200 motec series
Code level With active level:
Four−digit code number
Number
Menu level With active level:
Submenu number
Only active for operation with standard devices of
8200 vector or 8200 motec series
Code level With active level:
Two−digit subcode number
Parameter value
Parameter value with unit
Cursor
In the parameter level, the figure above the cursor
can be changed directly
Function keys
For description see the following table
efesotomasyon.com - Lenze
To Next Page
Loading...
