Lenze 9300 vector - Page 16

Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Changing and saving parameters
2
 16
EDKVF93−05 EN 1.0
ActionKey
sequence
Step
Display of SHPRG or SHPRG    Confirm change to accept the parameter
Display "OK"
Display  − The parameter has been accepted immediately
8. Enable the controller, if required 
1)
The drive runs again
9. Change to the code level
A  Display of the operating level
B  Display of the code with changed parameter
10. Change further parameters Restart the "loop" with step 1. or 3.
11. Save changed parameters
A     Select the code C0003 "PAR SAVE" in the menu
"Load/Store"
B  Change to the parameter level
Display "0" and "READY"
Select the parameter set in which
the parameters are to be saved
permanently
C  Save as parameter set 1:
ð Set "1" "Save PS1"
Save as parameter set 2:
ð Set "2" "Save PS2"
Save as parameter set 3:
ð Set "3" "Save PS3"
Save as parameter set 4:
ð Set "4" "Save PS4"
D   When "OK" is displayed, the settings are permanently
saved in the selected parameter set.
12.
Change to the code level
A  Display of the operating level
B  Display of C0003 "PAR SAVE"
13. Set parameters for another parameter
set
Restart the "loop" with step 1. or 3.
1)
The function of the  key can be programmed:
C0469 = 1: Controller inhibit
C0469 = 2: Quick stop (Lenze setting)
efesotomasyon.com - Lenze